FAQ's

The Morgan Square is engineered to work with most widely available tape measures.

By utilizing The Morgan Square to combine the measuring and marking steps into one fluid motion you will save up to 25% or more of the time spent on these processes.

No, by combining these steps, The Morgan Square will prove to be more accurate. Better accuracy means less errors, reducing the time spent on correcting these errors.

Yes, with increased accuracy during layout you can achieve more efficiency with material usage. In addition to the increased efficiency, less error correction will likely result in less material waste.

CL denotes the centerline. It located ¾” from each side of the Morgan Squares ruler, which is 1-1/2” wide. This will aid you in locating wall studs using the “on center” dimension. This will also assist in many project layout scenarios.

This mark is located 1-1/2 inches from the inside edge of the tongue. This is helpful for locating the King, trimmer, and cripple studs at wall openings. It is also very handy for many other situations during layout of projects large and small.

Kiwi Vision offers two convenient options for keeping your Morgan Square readily accessible. The belt clip allows you always keep your Morgan Square at your side. We also offer an insert for your tool pouch to support the Morgan Square between the two pouches.

The full line of Morgan Squares is only available on www.TheMorganSquare.com however, a limited selection is also available on www.amazon.com. You can also ask your favorite tool retail outlet as we are expanding our in store presence.

The Morgan Square will be featured at The National Hardware Show, The International Woodworking Fair, and select regional shows. Be sure to visit our booth at these exciting events.

While we have no answer to this, We bet you are glad we thought of it!